We have a wide variety of boards because of our wide versatility we can offer our customers distribution boards in both medium voltage (MV) and low voltage (BT).
Our technical department is always ready to carry out surveys at the end customer’s facilities to fully satisfy the operation service with which the board must count.
ASCO Series 7000 Power Transfer Switches
Ensures the reliable operation of ground fault protection systems and the reduction of transient voltages from the switching of unbalanced loads with the Emerson Network Power ASCO line of automatic and manual transfer switches. The ASCO 7000 Series power transfer switches feature overlapped or switched neutral options. This product can be obtained with a traditional configuration with a two position transfer and with closed or delayed transition operation modes.
Asco Series 7000 Power Transfer Switches
The power transfer switch of the ASCO 7000 Series connection combines automatic power switching with a protection device against overcurrents and disconnections in the power supply. These are typically installed in sites that have a single power supply and a single emergency power source.
ASCO 7000 Series Step-by-Step Power Switches
Synchronize and connect two independent power sources in pairs without interrupting the current flow with our ASCO 7000 Series gradual transfer switches. The switch can be programmed to maintain parallel operation of the two power supplies or transfer the load to the site generator and avoid the compromises caused by the blocking of the load.
Based on UL standards such as NEMA we have:
This board will give us the advantage of reducing manufacturing costs since having the synchronism switch and the control module in a cabinet on one side of the generator reduces the price of having a copper bus, as well as it will allow us to give the option of converting the electric plant into a mobile system.
The boards of the self-supported type as shown in the following figure have the advantage of concentrating the transfer boards and load centers united in a single block, allowing the operator to concentrate its operation and monitoring of the equipment in a single point.
The modules with which these boards are manufactured have all the functions associated with the verification of synchrony and self-synchronization. In addition, it has a perfect monitoring control of the load / discharge distribution, making said process in soft ramp mode
They offer a high level of security of electric backup to a load since it allows us to monitor the commercial network and have several power plants in backup and to ensure that if any of the plants fails the system will send a start signal to the other equipment through its MULTISET internal information system, giving us the security of a fully automatic process. By having a system with several generators in parallel it is possible that due to the level of load presented by the system this same command to start or stop the equipment interconnected in the system.
Alarm display
Standard alarms
These are provided and active at all times and are sent by message via cell phone to monitor the following:
